장바구니  |  연락하기  |  도움  | 
1588 8983  | 
전화번호: 1588 8983
계좌번호:하나은행 201-910031-70804

High Current Terminal Block Relays

XRU1H Series

High Current Terminal Block Relays | XRU1H Series

High Current Terminal Block Relays

88,060원 XRU1H24U

CE
  • 14 mm (0.55") Wide
  • Pluggable Relay Allows for Field Replacement
  • Convenient Plug-In Bridge System
  • LED Status Indication
  • DIN Rail Mount
  • IP67 Protected Optical Electronics
  • Wear-Resistant and Bounce-Free Switching
  • Insensitive to Shock and Vibration
  • Integrated Protection Circuit
  • Zero Voltage Switch at AC Output
  • Environmentally Friendly, Cadmium Free Contact Material
  • Electrical Isolation Between Input and Output
릴레이 / 타이머 - 관련 제품 보기

설명

The new XR Series relays include products designed to meet high continuous current and/or long electrical service life applications. The XR Series relays are plugin interfaces that connect to basic terminal blocks that use screw connection technology. Overall width is 14 mm (0.55"). These relays are best suited for applications that require higher continuous load currents than miniature relays can carry and switch. They can withstand inrush currents or brief overloads without damage, and allow for continuous load currents of up to 10 A. The XR Series Relay boasts an average service life of the contacts that is two or three times the normal life of a less powerful relay, resulting in service cost savings.

Accessories
Power Terminal Block
The XRAPLCESK power terminal block has the same shape as the relay modules and is used to feed in the bridging potentials. The nominal current is 32 A. When the total current is less than or equal to 6 A, supply can take place directly at the connecting terminal blocks of one of the connected relays.

End Cover
The XRAATPBK end cover is required at the start and stop of a relay strip. It can also be used for visual separation of groups of relays as well as separating relays with voltages greater than 250V and separating neighboring bridges with different potentials. It is equipped with pre-scored break out points at the bridging positions so that individual bridges can be passed through as needed. It may also be necessary to use the end cover between adjacent relays when three phases (L1, L2, L3) are used on the contact side of the relay.

Bridges
The XRAFBST colored, insulated plugin bridge system reduces wiring time by up to 70% compared to conventionally wired relays. The XRAFBST2, 2-position bridges, are suited for bridging a smaller number of relays and total currents < 6A. When a circuit is supplied from both sides, the circuit can be opened at any point, allowing all other modules to continue being supplied at the same time. The XRAFBST500 allow up to 80 modules to be bridged at one time. If bridges with different potentials meet in neighboring modules, the end cover XRAATPBK should be used. All bridges are equipped with a groove for removal with a standard screwdriver.

SPECIFICATIONS
Connection Data:
   Rigid Solid AWG (mm2): 26 to 14 (0.14 to 2.5)
   Flexible Stranded AWG (mm2): 26 to 14 (0.14 to 2.5)
Input Voltage:
   XRU1H24U: 24 Vac/Vdc
   XRU1H120U: 120 Vac/110 Vdc
Typical Input Current:
   XRU1H24U: 17.5 mA
   XRU1H120U: 4.5 mA (120 Vac)/4.2 mA (110 Vdc)
Typical Response Time:
   XRU1H24U: 8 mS
   XRU1H120U: 7 mS
Typical Release Time: 10 mS
Input Protection: Bridge rectifier
OUTPUT DATA
Contact Type: Single contact, SPDT
Contact Material: AgNi
Max Switching Voltage: 250 Vac/Vdc1
Min Switching Voltage: 12 Vac/Vdc
Limiting Continuous Current: 10 A (6 A)2
Max Inrush Current: 30 A (300 mS)
Min Switching Current: 100 mA
Min Switching Power: 1.2 W
MISCELLANEOUS DATA
Test Voltage I/O: 4 kV, 50 Hz, 1 min
Ambient Temp Range: -20 to 60°C (-4 to 140°F)
Rated Operating Mode: 100% Operating Factor
Inflammability Class: V0, in Accordance with UL 94
Mechanical Service Life: 3 x 107 cycles
1 The separating plate, XRAPLCESK, should be installed for voltages greater than 250V (L1, L2, L3) between identical terminal points of adjacent modules. Potential bridging is then possible with the XRAFBST bridge system.
2 The current rating for the normally open contact (#14) is 10 A. The current rating for the normally closed contact (#12) is 6 A and can be increased to 10 A by bridging the two #12 contact connections.
가격 확인(원하는 수량을 기입하십시오.)

다른 고객님이 함께 구매하신 제품 : 이 아이콘을 클릭하시면 기존 고객들께서 이 제품을 주문할 때 함께 구매하신 제품리스트가 보입니다.

제품 번호/Desc.
수량
설명
  
XRU1H120U
판매 상담  
배송: 
 
 
SPDT high current relay with 120 Vac/110 Vdc coil voltage
Click to expand/minimize a list of what others bought with theXRU1H24U
XRU1H24U
88,060원
배송: 2 주
 
SPDT high current relay with 24 Vac/Vdc coil voltage
REPLACEMENT RELAYS AND ACCESSORIES
  
XRR1H120U
36,420원
배송: 9 주
 
Replacement relay for XRU1H120U
  
XRR1H24U
29,270원
배송: 2 주
 
Replacement relay for XRU1H24U
  
XRAPLCESK
50,450원
배송: 2 주
 
Power terminal block
  
XRAATPBK
4,270원
배송: 9 주
 
Black end cover
  
XRAFBST2RD
2,920원
배송: 9 주
 
2-position red snap in jumper
  
XRAFBST2BU
2,920원
배송: 9 주
 
2-position blue snap in jumper
  
XRAFBST2GY
2,920원
배송: 9 주
 
2-position gray snap in jumper
  
XRAFBST500RD
44,920원
배송: 9 주
 
80-position red snap in jumper
  
XRAFBST500BU
44,920원
배송: 9 주
 
80-position blue snap in jumper
  
XRAFBST500GY
44,920원
배송: 9 주
 
80-position gray snap in jumper
  
XBMZB6
1,290원
배송: 9 주
 
6.2 mm white blank marker strip
Click to expand/minimize a list of what others bought with theXBANS3575P
XBANS3575P
24,600원
배송: 2 주
 
DIN rail, 35mm x 7.5mm x 2m, slotted
  
XBANS3575U
판매 상담  
배송: 
 
 
DIN rail, 35mm x 7.5mm x 2m, solid
Click to expand/minimize a list of what others bought with theXBANS3515P
XBANS3515P
판매 상담  
배송: 
 
 
DIN rail, 35mm x 15mm x 2m, slotted
  
XBANS3515U
45,090원
배송: 2 주
 
DIN rail, 35mm x 15mm x 2m, solid
  
XBANS3575PL
40,400원
배송: 2 주
 
DIN rail, 35mm x 7.5mm x 2m, slotted, aluminum
모든 가격은 원화로 표시되어 있습니다.
We noticed you are from the US. Visit your local site for regional offers and live support.